rainbowspot.blogg.se - Silent high torque clock movement

#Silent high torque clock movement how to

#Silent high torque clock movement how to

How to buy the Best Continuous Sweep Silent Clock MechanismĪ clock’s mechanism will determine whether it will run silently or with a clicking sound. Before you set the time, replace the battery on its slot.

They should be parallel to each other and lined up at 12 o clock.

This will secure the new silent running continuous sweep motor in place.

Place a washer on the part that threads through.

Now slide the movement shaft through the hole at the center of your clock case.

Top it off with a rubber/plastic gasket so that it lies between the mechanism and the back of the clock.

At this point, place the removable metal hanger(if any) on the shaft of your new silent clock movement.

Sometimes the mechanism will be housed on the clock back so that it does not move around. This will free the movement from the clock.

Use pliers to loosen the hex nut that sits between the clock face and hands.

If the clock hands are held on with friction, all of them can be pulled off with relative ease.

An old movement can only be released if you can access the clock’s hands. If spring clips have been used instead, remove them to get the clock out of the frame.

Unscrew the old mechanism from the dial face and take off the backpanel.

We have put together a step-by-step instruction guide below to help streamline this process. Your new continuous sweep silent clock movement will render useless if you cannot install it. Now you can hang this silent upgrade too! How to replace and install a Continuous Sweep Silent Clock Mechanism During installation, dont forget to place the removable hook on the clock movement. Its very important you get these dimensions correct. With a threaded length of 7/16 in, clocks no thicker than 0.25 inches will fit on the 3 / 4 inch long movement shaft.